Common Washing Machine Problems and How They Get Fixed
A washing machine usually gives warning signs before it fails completely. Knowing what the common faults look like helps you decide what to check yourself and when to call a technician. Here are the problems we see most often, what causes them and how they are fixed.
1. Water not draining
The most common cause is a clogged drain filter or a blocked drain hose, often from lint, coins, hairpins and detergent residue. A failing drain pump is the other usual suspect. What to check: switch the machine off at the plug, place a tray and a towel underneath, and clean the drain filter (check the user manual for its location). If the filter is clear and the machine still will not drain, the pump may need replacing.
2. Drum not spinning
On top-loaders, a worn belt, a faulty lid switch or a failing motor coupling is often responsible. On front-loaders, the door lock, the motor or the control board may be at fault. Overloading the machine can also stop the spin cycle. Remove some clothes and try again before assuming a fault.
3. Violent shaking or loud noise during spin
An unbalanced load is the simplest explanation, and redistributing the clothes may fix it. If it keeps happening, worn suspension or, on front-loaders, worn drum bearings are likely. A grinding noise that gets worse over time points to the bearings and is best repaired early, before the drum or shaft is damaged.
4. Machine not filling with water
Check that the tap is fully open and the inlet hose is not kinked. If so, the mesh filter on the water inlet valve may be clogged with mineral deposits or sediment, which is common where water is hard or carries a lot of minerals. Cleaning or replacing the inlet valve filter usually solves it.
5. Door will not open
Most machines keep the door locked until the cycle ends and the water has drained. Wait a few minutes and make sure the machine has drained. If the door stays locked, the door lock or the control board may need attention.
6. Water leaking
Leaks come from loose or cracked hoses, a worn door gasket on front-loaders, a faulty pump seal or too much detergent causing excess suds. Check the hose connections at the tap and at the back of the machine first. A leak from the base of the machine usually needs a technician.
7. Musty smell in a front-load machine
Moisture and detergent residue collect on the rubber door gasket and in the drain filter, especially in humid weather. Wipe the gasket after washing, leave the door open to dry, clean the drain filter regularly and run an occasional hot cleaning cycle. A torn or hardened gasket should be replaced.
8. Machine will not start
Check the power socket, the plug and the fuse, and make sure the door or lid is firmly closed. If the machine still shows no response or flashes an error code, the door switch, the power supply or the control board may be at fault. Fluctuating voltage can damage control boards, so tell the technician if the power supply in your area is unstable.
When to call a technician
You can safely clean filters, check hoses and rebalance a load. Anything involving the motor, the pump, the bearings, the control board or the inside of the machine should be left to a technician. Switch the machine off at the plug and avoid opening it yourself.
Is it worth repairing an older machine?
For pumps, belts, valves, door locks and many board faults, repair costs a fraction of a new machine, so repairing a machine that is four to six years old is usually good value. We will tell you plainly when a repair is not worth doing.
Washing machine repair near you
Expert Repair Hub repairs top-load and front-load washing machines at your home in Raipur, Ranchi and Jamshedpur. A technician diagnoses the fault on site and gives you a fixed quote before any repair begins. You can also read about our washing machine repair service.
Need Help With Your Appliance?
Book a certified technician for a doorstep repair with transparent pricing.

